Electrical power UNITS FOR LIFT TABLE 1
Standard Description
This power unit is developed solely for that little lift table,Consisting of large pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit is widely utilised from the sector of logistic products for example minifork lift, scissors lift and ariel working platforms. The lower-ing motion is managed by the solenoid valve with the speed managed through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
General Description
This energy unit is made exclusively for the medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve and also the velocity managed through the adjustable needle valve. Once the lift rises to a substantial positoin, however the energy provide is cut, the reducing motion is managed through the guide override perform.
Power UNITS FOR LIFT TABLE three
Common Description
This power unit is built solely for the significant lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve plus the pace managed by a pressure compensated flow manage valve.
Power UNITS FOR LIFT TABLE 4
General Description
This energy unit is intended exclusively for that substantial lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve and the speed controlled by the adjustable needle valve. Once the lift rises to a substantial positoin, but the electrical power supply is reduce, the reducing motion is managed by the manual override function.
Unique Notes
one. This electrical power unit is of S3 duty cycle, which might only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all the hydraulic components concerned in advance of set up of the electrical power unit.
3. Viscosity of your oil shoud be 15~46 cst,which really should also be clean and no cost of impurities.N46 hydraulic oil is recommended.
4. Oil transforming is required just after the first 100 operation hours,afterwards the moment each 3000 hours.
five. The power unit shown is designed to be mounted vertically.