1.A connecting hyperlink of an O-ring Chain for standard application is pre-coated with grease on the pins. Ahead of connection, confirm the grease to the surfaces of pins, and if the volume of grease is little, apply grease with bare hands. (If gloves are utilized, the grease is going to be absorbed by the gloves.)
Instance: When the connecting link (I) of an O-ring chain for basic application is
shipped, O-rings are fitted with the roots of the pins. In case the O-rings come loose because of vibration in the course of transport, refit the O-rings in to your roots of your pins.
In this case, make sure you return the grease collected at the roots in the pins for the central surfaces with the pins, far more at portion A than at portions B shown within the above illustration. (Portions A is worn due to sliding using the bushings.)
two.The chain is usually most easily linked over the teeth of the sprocket. Engage the links at both ends in the chain with the sprocket teeth and match connecting pins. Should the sprocket is often moved, the chain may also be connected around the loosened side.
three. Connecting procedure
1.Verify that O-rings are attached to the roots in the pins.
two.Should the quantity of grease utilized to the connecting pins is little, coat the pins with grease on the central portions.
3.Insert the connecting pins to the bushings of the inner backlinks at both ends.
4.Confirm the grease is applied on the whole encounter with the O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins into the connecting plate and although pressing the connecting plate, set up the spring clip. Verify no matter if the head (the end without a split) with the spring clip is turned from the feeding path on the chain. (See the next illustration.)
6.You should definitely confirm that the spring clip is securely fitted inside the clip grooves from the connecting pins.
This completes jointing in the connecting link. Note that grease around the surfaces of connecting pins and O-rings could be eliminated throughout installation operate. In this case, re-grease making use of the grease around the surface with the base chain or the grease during the polyethylene bag through which the connecting hyperlink was contained.